baby cot that converts into bed Baby cot that converts into bed

Children Cribs 6 Comments 0 We bought a Ikea Gulliver baby crib and some improvements needed to be made. We wanted to have the baby on same level as our own bed and without one side.

baby cot that converts into bed Baby cot that converts into bed

This gave easy access towards the baby during the night. However there was a warning label that prevented that configuration. Reason why this configuration was not allowed was the fact that ends of the bed were not secured well enough to hold the base in place.

That was easy task to solve with couple of zip ties and one nylock nut. Warning label Securing bottom of the bed to the ends.

The bolt for the pin was long enough to fit additional nyloc nut to the end and this way it was possible to create good place for the zip tie. Instead of nyloc nut, a butterfly nut could be used.

  • cot bed musical mobile argos
  • cot bed reviews 2018
  • lucia cot bed bolts
  • If you do not trust to zip ties and you are willing to make additional holes then a L-bracket could be used to secure the ends This is the outcome and this is how the bed was used couple of months before the baby learned how to roll. Then there was a risk that the baby would roll between the beds and fall to the floor. For an engineer that was just one more challenge. Crib on the same level as our bed and without one side The solution for this problem was to secure the beds together.

    I did not want to fix the beds together, but also allow an access between the beds if one want to sit on the bed next to the baby. This was possible with a cabin hooks and extended bolts to the crib.

    The cot features a 2-point adjustable mattress height mattress support is made from solid wood veneer plywood. Plus, the Ava Cot design has considered a lower height to enable easier access for parents.

    The cabin hooks were screwed under the bed so that you could just fit the hook to the baby crib bolt. Cabin hooks were screwed under the bed.

  • cot with removable side
  • ikea cot bed instructions
  • cot bed sheets argos
  • Tip of the hook was slightly bend inwards. The original bolt was replaced with a threaded rod, a washer plate, a normal nut and an allen head sleeve nut.

    sleigh cot bed with mattress

    The normal nut is not really needed, but I found pre-cut threaded rods that were bit too long. I did not want to cut those shorter so I just added one nut.

    The replacement bolt and the original bolt.

    baby cot that converts into bed Baby cot that converts into bed

    With this setup the crib was easy to secure to our bed, but it also gave an easy access between the beds. The other cabin hook was secured to the bolt with the rubber band, so it stayed in place when the crib was pivoted.

    It was just enough to open the hook from the one side. Easy access between the bed and crib. This is how we used the crib for first 6 months and when the baby started to crawl the bed base was lowered, but one side was still off for one month.

    Available in all three colours. Some have a sloped back, arm and headrests and a footstool. Caroline Hi there, I can advise that the mattress that is included is the one that is in the following link:

    Do not modify or attempt this hack unless you know how to ensure its continued safety.

    Comment

    Disar

    at 22:39

    It is easier to tell, than to make.

    Taukora

    at 21:11

    It is a pity, that now I can not express - there is no free time. I will return - I will necessarily express the opinion on this question.

    Mumi

    at 10:26

    It is a pity, that now I can not express - I am late for a meeting. I will be released - I will necessarily express the opinion on this question.

    Mogis

    at 19:36

    Idea shaking, I support.

    Leave a Comment